INSTRUCTIONS FOR INSTALLING YOUR SIDE WINDOW SHADES.  NOTE: THE SIDE WINDOW SHADE MAGNETS APPLY TO THE EXTERIOR OF THE WINDOW!

INSTALLATION VIDEO POSTING SOON

1. LAY YOUR SHADE ON A FLAT SURFACE WITH THE BACK SIDE FACING UP
2. SLIDE OFF ONE THIN BLACK MAGNET AT A TIME AND PLACE ON EACH POCKET (NOTE THAT THE BACK CORNER WHERE THE SLIDING WINDOW IS WILL TAKE A SPACING OR STACKER MAGNET)
3. CLEAN THE SURFACE OF EACH MAGNET WITH ISOPROPYL ALCOHOL
4. PLACE ONE ADHESIVE DOT ON EACH MAGNET WITH TOP PROTECTIVE FILM STILL ON
5. MANIPULATE THE MAGNETS SO THEY ARE AS FAR TOWARDS THE SEAM AS POSSIBLE
6. CLEAN THE OUTSIDE OF THE WINDOW WHERE THE MAGNETS WILL MOUNT FIRST WITH A PRODUCT THAT WILL REMOVE WAX FROM THE GLASS, THEN WITH A 50/50 MIXTURE OF ISOPROPY ALCOHOL AND WATER.
7. APPLY THE 3M AP115 SILANE GLASS TREATMENT PER 3M'S INSTRUCTIONS WHICH ARE INCLUDEDED WITH YOUR SHADE.
   
8. HOLD THE SHADE UP TO THE WINDOW, CENTER IT WHERE IT IS EVEN ALL AROUND, PEEL THE FILM OF ONE MAGNET AND PRESS IT AGAINST THE GLASS WITH PRESSURE FOR 15 SECONDS,
9. REPEAT THIS UNTIL THE SHADE IS COMPLETELY MOUNTED.
10. REMOVE THE SHADE BY SHARPLY SLIDING THE SHADE STRAIGHT DOWN, THEN RE-APPLY PRESSURE TO EACH MAGNET, ALLOW THE ADHESIVE TIME TO CURE (24 HOURS SHOULD BE SUFFICIENT)  BEFORE RE INSTALLING THE SHADE IN THE NORMAL WAY WITH THE ROD.

TIPS.

FOR THE SLIDING WINDOW, APPLY THE ALUMINUM SPACER TO THE CORNER OF THE SLIDING WINDOW, THIS CARRIES THE FABRIC ON THE SAME PLANE AS THE FIXED GLASS, MOUNT WITH THE BLACK MAGNET TO THE OUTSIDE.

DO NOT INITIALLY INSTALL  THESE IN DAMP OR WET WEATHER, ONCE THE ADHESIVE CURES COMPLETELY, USUALLY 72 HOURS THE VHB ADHESIVE WILL BE RESILIANT TO MOISTURE.

FIT THE SHADE AND TIGHTEN AS YOU APPLY EACH MAGNET FOR A NICE FIT.